in Games, How-To

A super-quick, cheap, and easy-to-install method for adding some personalization to your fightstick is to replace the stock balltop with a different one, maybe of a different color or from a different manufacturer.

Parts Used in This How To

For this how to, we’re using a MadCatz TE2, which comes with a Sanwa JLF-TP-8YT lever as a stock part. Those levers come with an LB-35 balltop.

  • Sanwa LB-35 Balltop (35mm, yellow)
  • Seimitsu LB-39 Balltop (35mm, blue)

Any 35mm balltop will work when following this tutorial. This includes stock balltops from Sanwa and Seimitsu, as well as the stock balltop on the Hori Hayabusa lever, and many custom balltop replacements. (The vast majority of balltops you can buy are 35mm.)

Tools Used in This How To

  • Flathead screwdriver (the tool included with the TE2 counts)

How To Replace the Balltop

OK, first, open up your stick or otherwise get it to the point where you can get at the underside of the mounting panel. On the TE2, use the catch button at the front of the stick and swing the panel up.

IMG_0952

Turn the stick so you can access either side of the mounting panel at the same time.

With one hand (I’m left-handed), grab the balltop that’s currently installed.

IMG_0954

With your other hand, take the flathead screwdriver and insert it into the screwhead on the bottom side of the joystick lever. Hold the screwdriver head there so you can apply torque to the joystic shaft without it rotating entirely. (If you want to see what that looks like, just rotate the balltop without having the screwdriver in place.)

IMG_0955

Using one hand on the balltop and the other hand on the screwdriver handle, rotate the two so the balltop starts separating from the shaft. After a few rotations, it should look like this:

IMG_0956

Once you have removed the balltop, set it aside. To stop it from rolling around on your work surface, set it down with the screw mount flat on the surface.

Grab the new balltop you want to install, and reverse the process you used to remove the previous one. With one hand on the balltop and the other on the screwdriver handle, rotate the two so the new balltop tightens on the lever.

IMG_0959

Slowly but firmly continue to screw the balltop onto the mount until you feel resistance. Give it one last gentle tighten and you’re done. Remove the screwdriver from the bottom of the lever assembly and check to make sure the new balltop is flush with either the shaft itself or the shaft cover if your stick has one.

IMG_0960

You’re done! Close the stick up and give it a test. It should freely rotate in your hand without coming away from the shaft.